To Next PageTo Next Page
Need help?Do you have a question about the Top Flite AT-6 Texan and is the answer not in the manual?
Emphasizes the AT-6's complexity, need for precise assembly, and safe handling.
Stresses using reliable radio systems, checking all equipment, and seeking pilot assistance.
Warns about fiberglass dust and recommends safety gear and proper cleanup procedures.
Lists required radio equipment and recommended engines for the AT-6 model.
Lists essential adhesives and building supplies needed to complete the model assembly.
Lists optional tools and explains screw designation systems for model construction.
Offers guidance on adhesive application, test fitting, and MonoKote film for covering and repairs.
Provides contact details for support and enumerates all included kit parts.
Lists available replacement parts with order numbers for purchasing from hobby suppliers.
Instructions on inspecting and preparing wing parts for assembly.
Step-by-step guide for installing hinges and attaching ailerons and flaps to the wing.
Instructions for preparing servo covers, mounting servos, and routing servo leads through the wing.
Guides on connecting control horns to surfaces and pushrods to servos.
Instructions for fitting hardwood joiners and gluing wing panels together securely.
Details installing joiner covers and ensuring the structural integrity of the joined wing panels.
Details installing the retract servo and mounting the main landing gear components.
Guides on attaching wheels, axles, and performing final adjustments for the landing gear system.
Step-by-step instructions for installing the horizontal stabilizer, elevators, and rudder onto the fuselage.
Details connecting pushrods, installing elevator/rudder hinges, and securing tail wheel assembly.
Guides on mounting the engine, fuel tank, and installing fuel tubing.
Details installing the battery tray and routing the throttle pushrod for servo connection.
Guides on positioning and installing servos, receiver, and battery, and connecting system components.
Guides on setting up the retract servo arm and adjusting its travel for proper gear operation.
Details installing retract wires into connectors and securing them with screws and threadlock.
Guides on mounting cowl blocks, positioning the cowl, and preparing the dummy engine for cooling.
Details sliding the dummy engine and cowl into place and securing them with adhesive.
Guides on gluing cockpit floor, instrument panels, pilots, and other interior details.
Instructions for attaching the canopy, exhaust stack, and air scoops to the fuselage.
Provides guidance on cutting and placing decals using reference pictures from the manual and box.
Steps to verify control surface responses and set throws to recommended values.
Crucial procedure for determining and adjusting the Center of Gravity for stable flight.
Instructions for labeling the model and charging batteries for operation.
Emphasizes propeller balancing and performing essential ground and range checks before flight.
Essential safety measures for handling fuel, engines, and general operation.
Key AMA safety principles and a comprehensive preflight preparation checklist.
Detailed instructions for safe takeoff and adjusting fuel mixture for optimal engine performance.
Advice on flying, trimming, and executing safe landings, including flap usage.
General