To Next PageTo Next Page
Need help?Do you have a question about the Top Flite T-34B MENTOR and is the answer not in the manual?
Essential guidelines for safe operation of the model.
Guidance on choosing the appropriate engine size for the model.
Information on available exhaust systems for the model.
Details on installing retractable landing gear from Robart.
Information about the optional scale flaps and their benefits.
Details on how the T-34B Mentor was designed.
Explanation of the I-Beam wing spar construction.
Design considerations for landing gear installation.
Conventional fuselage design and canopy details.
List of additional items needed to complete the model.
Checklist of necessary glues, fillers, and tools.
Instructions for creating the skin planks for tail surfaces.
Detailed guide on creating precise hinge slots for control surfaces.
Crucial advice for correctly installing CA hinges.
Instructions for creating the wing skin panels.
Step-by-step instructions for assembling the outer wing sections.
Applying the top sheeting to the wing panels.
Final steps for completing the outer wing panels.
Steps to prepare the wing bottom for sheeting installation.
Applying bottom sheeting to the wing panels.
Applying top sheeting to the wing center section.
Initial steps and checks before fuselage construction.
Steps for constructing the lower fuselage structure.
Instructions for installing servos in the fuselage.
Completing the structural framing of the fuselage.
Applying sheeting to the fuselage sides.
Ensuring the horizontal stabilizer is level.
Attaching the vertical fin and rudder assembly.
Applying balsa sheeting to form the turtle deck.
Connecting pushrods for rudder and elevator control.
Applying sheeting to the bottom of the fuselage.
Instructions for installing the fixed nose landing gear.
Instructions for installing the retractable nose landing gear.
Setting up the pull-pull system for nose steering.
Connecting the throttle servo and linkage.
Applying sheeting to the forward deck area.
Placing and securing the fuel tank and fuselage formers.
Applying sheeting to the forward bottom fuselage section.
Applying bottom sheeting to the wing center section.
Adjusting and attaching the model's cowl.
Applying fuelproof coating to protect the model.
Filling and sanding the cowl for a smooth finish.
Step-by-step order for applying Monokote film.
Adding panel lines and details to the model.
Steps to achieve the correct center of gravity for stable flight.
Technique for accurately marking the CG balance point.
Correcting wing weight imbalance for stable flight.
Mounting radio and retract system components.
Recommended control surface movements for optimal flight.
Procedures for charging model batteries.
Importance and method for balancing propellers.
Guidance on selecting a suitable flying location.
Essential checks before the first flight.
Critical safety measures for operating model engines.
Testing radio control range for safety.
Adjusting engine fuel mixture for optimal performance.
Techniques for a safe and successful model takeoff.
Advice on handling the model during flight.
Guidance for performing safe landings.
How to use flaps for landing and takeoff.
General