30
3.8 Tooth Learning
3.10 Injector Coding
3.11 Tire Pressure Reset
3.12 Suspension Level Calibration
3.13 AFS (Adaptive Front-lighting System) Reset
3.9 Anti-theft Matching
This function can perform tooth learning for the car, to turn off the MIL
This function can write injector actual code or rewrite code in the ECU to the injector
code of the corresponding cylinder, so as to have more accurately control or correct
cylinder injection quantity.
This function can reset the tire pressure and turn off the tire pressure fault indicator
when the car tire pressure fault indicator light is on.
This function can adjust the vehicle body height sensor for level calibration after
replacing the vehicle height sensor or control module in the air suspension system, or
when the vehicle level is not correct.
This function enables you to initialize the adaptive headlamp system.
This function can match the anti-theft key after replacing the ignition key, ignition
switch, instrument cluster, engine control unit (ECU), body control module (BCM), and
remote control battery.
It needs to be performed in the following cases:
It needs to be performed in the following cases:
•
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is replaced.
•
The DTC “tooth not learned” is present.
•
After the ECU or injector is replaced.
3.14 A/T Learning
3.15 Sunroof Initialization
This function helps complete the gearbox self-learning to improve gear shifting quality.
This function enables you to set the sunroof lock off, or closed when it rains; the sliding
/ tilting sunroof memory function; the temperature threshold outside the car etc.
It needs to be performed in the following cases:
•
When the gearbox is disassembled or repaired (after some of the car battery is
powered off), which leads to shift delay or impact problem.
To Next Page
Loading...
