32 | P a g e
Follow these steps for battery charging.
1) Insert the charger plug (8) in the charging socket (10) located on the right side of the tiller column.
2) Plug the charger power cord (9) into a wall socket (11).
3) When charging is complete, remove the charger power cord (9) from the wall socket (11) and then remove
the charger plug (8) from the charging socket (10).
4) Under ideal storage conditions, batteries that were charged to full capacity and were not used should be
recharged every month
5) If you expect not to use your scooter for an extended period of time, we recommend charging it for two
days and then disconnecting the batteries.
6) If you have not used your scooter for an extended period of time, charge the batteries for at least 24 hours
before driving.
Note:
There is NO need to disconnect the charging plug immediately after the charging is complete.
However, DO NOT leave the charger connected to the batteries FOR MORE THAN TWO WEEKS.
As long as the charging plug is in the charging socket, the electronic control of the scooter automatically
cuts all power to the electric system and it cannot be driven.
The charger supplied is suitable for charging lead acid dry/gel batteries. Use only the defined type of
charger. Before using any other type of charger, check with your dealer.
To Next Page
Loading...
