To Next PageTo Next Page
Need help?Do you have a question about the Topmodel F3K FLITZ 2 and is the answer not in the manual?
Provides key technical specifications for the sailplane.
Lists recommended radio equipment and components for the model.
Lists necessary adhesives and tools for assembling the kit.
Details recommended radio system, receiver, servos, and battery.
Comprehensive list of all parts included in the FLITZ 2 kit.
Preparing servo bays and initial linkage setup for the wing.
Fitting control horns, linkages, and preparing servo installation.
Centering servos, routing wires, and internal servo mounting.
Connecting wing electrical connectors and attaching the wing.
Creating and installing torsion springs for elevator and rudder.
Positioning and gluing the horizontal stabilizer.
Installing elevator and rudder control cables and linkages.
Gluing the vertical stabilizer to the fuselage.
Routing the rudder control cable through the fuselage.
Routing the elevator control cable to the servo.
Aligning and marking the PEG reinforcement on the wing.
Cutting the wingtip to accommodate the PEG.
Hollowing the wing foam to fit the PEG reinforcement.
Fitting the PEG reinforcement into the prepared wing slot.
Adjusting the PEG for a perfect fit and preparing for resin.
Drilling a vent hole and preparing for epoxy resin injection.
Injecting epoxy resin into the wing cavity for reinforcement.
Securing the PEG and reinforcement with resin.
Finishing PEG installation and sanding carbon reinforcements.
Installing the receiver and battery, and preparing for final balancing.
Instructions for setting the correct center of gravity for the model.
Recommended control surface deflections and exponential settings.
Details on different flight modes and airbrake usage.
General
