Topper Topaz UNO PLUS - Topaz UNO RACEX Rigging; Gennaker Kit Attachment; Gennaker Halyard Routing

10
3. Tie one end of the halyard to the head of the gennaker
using a bowline knot.
4. Take the other end of the gennaker halyard through
the small block at the base of the mast.
5. Then take it underneath the sock, forward to the bow
of the boat until you come to a small block. Take the
halyard through this block.
6. Then take the halyard back towards the stern
of the boat, down through the cleat fitting in the
cockpit of the boat as shown.
7. Then take the halyard through the starboard
(right hand side from back of boat) block as shown.
TOPAZUNO
RACEX
TOPAZ UNO RACE X
RIGGING INSTRUCTIONS
TOPAZ UNO RACE X
INVENTORY
As TOPAZ UNO RACE PLUS with the addition of:
RACE X Gennaker Sail (8.00m2)
Gennaker Kit
1. Attach the two shroud wires and block using the shackle to
the metal clip attached to the upper mast above the jib fitting.
2. Then thread the gennaker halyard through the block
and pull down to the base of the mast to ensure that
when you raise the mast into the upright position in the
boat that you can reach both ends.
8. And then up the inside of the gennaker sock.