11
9. The halyard then comes out through the chute mouth.
11. Then tie off using a bowline knot to the criss-cross
patch above. You will now have completed a continuous
loop for the sail and the halyard.
14. Thread the gennaker sheet through the auto ratchet
across the boat and around the front of the mast and jib
12. Tie the pole end line to the tack end of the gennaker
using a bowline knot.
13. Attach the shroud wires to the hull shroud pin using
the carbine hooks.
10. Then feed the halyard through the patch as shown.
15. Then thread through the eye at the clew end. Feed
through the opposite sides. Then tie a figure of eight knot
on each side of the gennaker sail.
To Next Page
Loading...
