©2020 拓威航空 版权所有
3 installation and setting
3.1 Installation Preparation
1. Types of equipment supporting installation
F10A pod shall be equipped with HDMI image transmission to realize
image transmission. Please select the appropriate image transmission
device.
2. Supported micro SD card types
Up to 64GB. Please use micro SD card of class 10 or uhs-1 and above to
ensure normal video recording.
3.2 installation of pod
1. F10A pod is designed with the main body and damping structure separated,
which is convenient for users to modify the damping structure and layout
according to their own aircraft structure. Refer to 4 structural drawing for damping
drawing. You can also purchase the existing damping structure scheme.
2. According to the actual situation of the user, choose to install the shock
absorption group to the appropriate position of the aircraft first, and then fix the
F10A pod to the shock absorption group; or fix the F10A pod and the shock
absorption group first, and then fix the shock absorption group to the appropriate
position of the UAV.
If using SBUs control, connect the SBUs receiver to the pod SBUs line. F10A SBUs
line provides 5V 0.5A power supply output, without the need to supply the receiver
separately. (Note: in order to ensure the stable operation of the pod, please do not
connect other equipment that needs to be powered by the receiver, such as the
servo, etc.)
3.3 Software installation
F10A upgrade setting software has three functions of pod firmware upgrade, pod
calibration and SBUs channel setting.
1. After decompressing the F10A pod software compression package, there are two
files, which are F10A upgrade setting software (installation free) and serial port
drive. After installing the serial driver, open F10A to upgrade the setting software.
2. First power on the pod (12-25v), then connect the pod to the computer through
To Next Page
Loading...