The Torch/G700 Tactical Flashlight Instruction Manual
Option 1 - Use 3 AAA Batteries (not included)
• To use 3 AAA batteries, you’ll use the AAA battery adapter that is stored inside of
the flashlight.
• On the bottom end of the flashlight, close to the green power switch (power
switch maybe another color), twist the tail end of the flashlight until tail end is
fully unscrewed.
• Locate and remove the AAA battery adapter from the flashlight.
• Install each AAA battery so the negative side of the battery is in contact with each
spring.
• When all 3 batteries are installed in the adapter, place the adapter back inside the
flashlight. The adapter’s male end should point towards the flashlight head unit.
• Screw the tail piece of the flashlight until firmly tightened.
• Test to see if the batteries are functioning by pressing the green power switch
(power switch maybe another color) located on the back of the flashlight.
Option 2 - Use an 18650 Rechargeable Battery like the ones
in the Torch Duo Battery Pack available here:
http://www.freeflashlight.com/battery
• To use the rechargeable battery, you’ll use the clear plastic bat-
tery holder included with your flashlight.
• On the bottom end of the flashlight, close to the green power
switch (power switch maybe another color), twist the tail end
of the flashlight until tail end is fully unscrewed.
• Locate and remove the AAA battery adapter from the flashlight.
• Locate the clear plastic battery holder. Place this holder inside
the battery slot.
• Take the 18650 battery and insert it in the slot firmly inside the
plastic holder inside the flashlight. lnsert the positive end of the
battery facing the flashlight head unit.
• Screw the tail piece of the flashlight until firmly tightened.
• Test to make sure the battery installation is functioning properly
by pressing the green power switch (power switch maybe
another color)
Charging Your Device:
Directions for Using the Torch Duo Battery Pack (Optional)
• Locate the 18650 battery
• Locate the wall charger unit provided with the Torch Duo Battery Pack.
• Place the 18650 battery in the charger with the positive side facing the light
on the charger.
• Plug the wall charger into an available wall outlet.
• If the battery is installed correctly, you will see a red light
(battery color may vary)
• When a battery is fully charged the red light will turn green.