To Next Page
M
migueljohnsonAug 9, 2025
What to do if the piston will not advance or retract on my TorcUP TU-2?
- AAnn GuerreroAug 9, 2025
If the piston on your TorcUP Tools fails to advance or retract, there are several potential causes: * The couplers might not be securely attached to the tool or pump. Ensure all coupler connections are properly connected. * A coupler might be defective. Replace any defective couplers. * The remote control switch could be defective. Replace the switch and/or control pendant. * There could be dirt in the direction-control valve of the pump unit. Disassemble the pump and clean the direction-control valve.
General
