Torin T32052 - Safety Markings and Symbols; Safety Markings and Instructions; Safety Alert Symbol Guide

4
SAFETY MARKINGS
WARNING!
1. Study, understand, and follow all instructions before operating this device.
2. Do not exceed rated capacity.
3. Be aware of dynamic loading! Sudden load movements may briey create excess load causing
product failure.
4. Do not operate while puller is restricted from forming a straight line with loading direction.
5. Do not operate puller with twisted, kinked, or damaged wire rope. Inspect wire rope carefully
before every use.
6. Do not operate a damaged or malfunctioning puller. Inspect puller carefully and test operation
before every use.
7. Do not use for vertical lifting. Do not lift people. Do not lift loads over people. Unsafe, tilting, or
falling loads can injure or kill people.
8. Do not operate puller with a lever extension.
9. Do not operate with wire rope not centered in pulley groove.
10. Do not remove or cover warning labels and/or tags, these carry important safety information.
11. No alterations shall be made to this product.
12. Only attachments and/or adapters installed by the manufacturer shall be used.
13. Do not use this product for any use other than the manufacturer specied usage.
14. Failure to heed these markings may result in personal injury and/or property damage.
IMPORTANT SAFETY INFORMATION
SAFETY
ALERT
SYMBOL
This symbol is used to call your attention to
hazards or unsafe practices which could result
in an injury or property damage. The signal
word, defined below, indicates the severity of
the hazard. The message after the signal word
provides information for pre-venting or avoiding
the hazard.
Immediate hazards which, if not avoided, WILL result in
severe injury or death.
Hazards which, if not avoided, COULD result in severe
injury or death.
Hazards or unsafe practices which, if not avoided, MAY
result in injury or property damage.
DAMGER
WARNING
CAUTION
Do not operate the cable puller in a
hazardous environment. Hazards
include ammable liquids and gases.
Failure to observe this warning will
result in severe injury or death.
DAMGER
Always lock boom components in place
during assembly or dis-assembly. Adding
and removing components may cause
rotation. Parts may strike nearby personnel.
Failure to observe this warning could
result in severe injury or death.
WARNING
Read and understand all of the
instructions and safety information in this
manual before operating or servicing this
tool.
Failure to observe this warning will result in
severe injury or death.
DAMGER