TECHNICAL DOCUMENT
TORMACH.COM
Page 1
©Tormach® 2017. All rights reserved.
Specicaons subject to change without noce.
TD10039_PCNC1100_PowerDrawbar_0717A
PCNC 1100 Power Drawbar Installation
Product Idencaon: PCNC 1100 Power Drawbar (PN 31706)
Purpose: This document details installaon of the Power Drawbar on the PCNC 1100 mill.
Qty. PCNC 1100 Power Drawbar PN
2 1/4 inch Plastic Tube: 112 mm 31457
1 1/4-20 x 1 Screw w/ Flat Washer, Nut 31331
2 105A Wire Labels —
2 Air Fitting: Elbow 35924
2 Air Fitting: T-connector 35923
1
Cable Carrier End Bolt w/ Washer, Lock
Washer
—
1 Control Assembly 31470
1 Cylinder Assembly 31380
1 Drawbar 31320
1 Drawbar Bushing 31330
1 Eccentric Mounting Post 31316
1 Leg Bracket 31318
1 M6 x 25 mm Screw w/ Flat Washer 32371
1 M6 x 45 mm Screw w/ Lock Washer 31332
4 M16 Flat Washer 31445
1 Pendant 31471
1 Plastic Mount Tab 31460
1 Sheet Metal Screw 31718
1 Spanner Pin Wrench 31118
1 Spindle Flange w/ Set Screw 31321
8 Spring Washers 31319
1 Thread Seal Tape —
1 Wire Tie 31719
NOTE: If any of these items are missing, contact Tormach
Customer Service for a replacement at (608) 849-8381.
To Next Page
Need help?
General
