Tormatic T100 DES - Declaration of Conformity and Installation; Compliance with Key EU Directives

Retain these installation, operating and maintenance instructions for the full duration of the operator’s service life!
GB
Retain these installation, operating and maintenance instructions for the full duration of the operator’s service life!
GB
Proof of inspection and maintenance of the door system
Date
Work performed / necessary measures
Initial operation, first testing
Test carried out
Signature / address
of the company
Defects rectified
Signature / address
of the company
Declaration
for the installation of an incomplete machine
in accordance with the Machinery Directive 2006/42/EC, annex II part 1B
Novoferm tormatic GmbH
Eisenhüttenweg 6
D-44145 Dortmund
hereby declares that the operators
NovoShaft 5.15, 5.20, 5.24, 9.15, 9.20, 2.24, 14.21 and 6.65 DU
in connection with the control unit
T100 DES
comply with the Machinery Directive 2006/42/EC and are intended for installing into a door system.
 The following basic safety requirements in accordance with annex I hereto were applied:
- General principles no. 1
- 1.2.1 Safety and reliability of control systems:
Input STOP A: PL C
Input STOP B: kat. 2 / PL C
Input STOP C: kat. 2 / PL C
In doing so, the harmonized standards EN12978, EN13849-1 and EN60335-1
were applied.
 The technical documents in accordance with annex VII B were drawn up.
We are committed to submit
the special documents with regard to the complete machine via our documentation department to the
market surveillance authorities on a reasoned request.
 Conformity is in accordance with the provisions of the EC Construction Products Directive 89/106/EC.
For the part "Operating Forces" the corresponding initial tests in cooperation with the recognized testing
bodies were performed. In doing so, the harmonized standards EN13241, EN12453 and EN12445 were
applied.
 Conformity is in accordance with the Low-voltage Directive 2014/35/EU
 Conformity is in accordance with the EMC Directive 2014/30/EU
The product may not be put into service until it has been established that the door system complies with
the provisions of the Machinery Directive.
Dortmund, 09.01.2017
______________________
Dirk Gößling
- Managing Director -
Declaration of Conformity and Installation