75
Gouge Jig SVD-185
Grinding direction:
Away from the edge.
Design
The jig comprises a tool holder (1) which runs in a sleeve (2). The tool is aligned with a disc
(4) and tightened with a knob screw (5). There is a washer (6) for wide gouges. The stop ring
(7) can be set for a convex bevel with a screw (8).
The tool holder can be set in any position from 0 to 6 with the 5 mm Allen key (9). The setting
can be noted on a special prole label (10), which is attached to the ferrule. A special pen,
which works on these labels is included (11). For turning cutters there is a shaft (12) with a
mounting screw (13) and a 2,5 mm Allen key (14).
Positioning of Machine
TURNING TOOLS
Bowl gouges
Spindle gouges
Turning cutters
CARVING TOOLS
Curved gouges
Spoon-shaped gouges
Back bent gouges
Down bent gouges
Curved V-tools
Max tool width 25 mm (1").
To Next Page
Need help?
General
