8
WARNING: Plastic bags or lm can be dangerous. To avoid danger of suf-
focation, keep away from babies and children.
The dual Suction System is packaged for convenience and requires mini-
mal assembly.
The only tool you will need is a Phillips head screwdriver.
1. Slide the handle Tube into the Connector, aligning the hole in the Handle
Tube with the molded hole at the top of the Connector.
2. Hold the hex nut in front of the Connector in the hex shaped cavity while
inserting the screw with your nger from the back. Tighten the screw while
placing your nger over the hex cavity to hold the hex nut in place. After a
few turns, tighten further with a Phillips head screwdriver. Do not overtight-
en.
3. Slide screw through plastic Cord Hook from the inside of Cloth Bag. Align
screw with hole in Handle Tube. Tighten screw.
4. Remove screw from Filter Cover. Remove Filter Cover. Insert the Con-
nector Plug into the back of the unit at the rear of the Powerfoot – Make
sure the Connector Plug is fully inserted. Replace Filter Cover. Replace
Filter Cover Screw.
Your Vacuum cleaner is now ready to use.
Tip. Before cleaning under low furniture, always check area rst for objects
that might harm the Rotating Cleaning Brush or get caught in the Dust Tube.
Power Supply
The Power Cord is stored at the back of the vacuum cleaner, and is looped
around the Quick Release Cord Hooks. The polarized Power Source Plug
is designed to attach to the Power Cord during storage. Before using, make
sure the Connector Plug is securely attached to the Powerfoot and that the
Power Source Plug is plugged into a polarized outlet.
Power Switch
The Power Switch is located in the Handle of the cleaner. Push down (I) to
turn ON. Push up (O ) to turn OFF.
Power Cord Storage
When you are nished using your vacuum, return it to the upright position.
Make sure the vacuum is turned OFF. Always unplug the vacuum by grasp-
ing the Power Source Plug (NOT the Power Cord) and disconnecting from
the outlet. Properly store the Power Cord by winding the cord around the
Quick Release Cord Hooks on the back of the vacuum in a continuous loop,
or by hanging the cord on the Cord Storage Hook located on the front of the
vacuum. Attach the Power Source Plug to the Power Cord.
Operation
This vacuum, with Dual Suction System is designed to effectively and safely
clean all types of carpeting, wood, linoleum, and vinyl oors. Its wide 14-inch
Powerfoot makes cleaning quick and easy.
To place the vacuum in position for use, lightly press your foot on the Power-
foot and tip the Handle backwards.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
To Next Page
Loading...
Need help?
General
