62
Transponder Frequency – this is the satellite transponder frequency in kHz.
Symbol Rate – this is the digital satellite symbol rate in seconds (symbols/sec)
Polarization – this is the transponder signal polarization
Error Correction – this is the transponder signal error correction type.
LNB Number – this is the LNB number. If there is no DiseqC support then the LNB number should be set
to disabled DiseqC support (default ‘0’)
ATSC Transponder Management
This section allows ATSC card configuration. ATSC cards are commonly used in USA.
Transponder Name – this is the name of the transponder or service that is used
Transponder Frequency – this is the transponder frequency in kHz.
Modulation – this is the digital signal modulation type.
To setup DVB Digital Service digital service (DVB-S, DVB-T, DVB-C, ATSC), please use the following
steps:
1. Setup the Transponder Profile. The DVB Management Profile represents the configuration
required to scan and capture of the digital video/audio signal.
2. Scan the channel via the TV interface or the Web Admin console by selecting the DVB
Management/Edit/Scan Transponder.
3. The scan should present the scanned digital channels into the PPV/DVB section of the TV
interface and on the Web Admin console /Video/DVB section.
To Next Page
Loading...
Need help?
General