15
MAINTENANCE:
WARNING!! Always unplug power cord before cleaning,
making adjustments or repairs.
AFTER EACH USE:
• Thoroughly flush out both tanks. HINT: To clean the recovery tank turn
upside down and lightly spray into the vacuum intake. this will
“backflush” the filter screen and float shut-off ball. Drain tank through
the hose intake.
• Wipe down entire unit with cleaning solution.
• Flush pump system with 1 quart clean water with 1 ounce white vinegar.
• Remove and clean foam vacuum filter. Remove lint from vacuum motor
intake screen. Store with tanks exposed in clean dry place.
• Inspect power cord for damage. Replace if necessary. Wipe and coil the
cord from machine to the plug then place coiled cord through molded
handle for storage or transport.
• Remove lint from hand tool opening. HINT: Back-flush through vacuum
hose end.
PERIODIC MAINTENANCE
• It is highly recommended that once a month you flush the ProSpot out
with a 8 to 1 ratio of water to white vinegar or anti-browning solution
through the extractor. This will help to prevent the build up of alkaline
residue.
• If the spray jet becomes clogged, remove and wash it thoroughly and
blow dry. Do not use wire or pins to clean the nozzle as this will cause
the spray pattern to become distorted, thereby giving you a streaking
pattern on the carpeting.
• Once a month, inspect all electrical cables, hoses, filters and
connections in the ProSpot. If you see something that should be
repaired or replaced this should be reported and repaired. Little things
are easy to forget, but as these little things add up you end up with a
cluster of problems that will cost you more in the long run.
• Inspect the vacuum motor carbon brushes after every 700 hours of use
replace, if necessary.
• Be sure to use genuine Tornado parts and that service is provided by an
authorized Tornado Service Center. 1-800-VACUUMS Use of non-OEM
parts will void the warranty.
To Next Page
Loading...
