How to remove detergent residue from laundry after washing in Tornado TWV-FN710WTOA?
If your laundry has detergent residue after washing in your Tornado Washer, it may be due to non-dissolving particles in some detergents that appear as white spots. To resolve this, perform an extra rinse cycle or clean your laundry with a brush after it dries.
Why my Tornado TWV-FN710WTOA Washer does not start?
If your Tornado Washer doesn't start, several factors could be at play. First, ensure the machine is properly plugged into a functioning power outlet. Check the fuses and replace them if they are faulty. Verify that there is mains power supply. Make sure you've pressed the Start/Pause button. Also, confirm that the program dial is set to the desired position, and importantly, that the machine door is completely closed.
What to do if my Tornado Washer does not intake water?
If your Tornado Washer isn't filling with water, start by checking if the water tap is turned on. Next, inspect the water inlet hose to ensure it's not twisted, and untwist it if necessary. Also, the water inlet hose or inlet filters might be clogged, so clean them thoroughly. Finally, ensure that the machine door is completely closed.
How to stop my Tornado Washer from vibrating?
If your Tornado Washer is vibrating excessively, make sure the feet are properly adjusted to stabilize the machine. Check for and remove any transit bolts that were fitted for transportation. Be mindful of the load size; while a small load won't prevent operation, an overloaded or unevenly spread laundry can cause vibrations, so avoid overloading and spread laundry evenly. Finally, ensure that the washing machine is not placed on a hard surface.
Why my Tornado Washer does not discharge water?
If your Tornado Washer isn't discharging water, start by inspecting the drain hose for any clogs or twists; clean or untwist it as needed. Then, check the pump filter for clogs and clean it thoroughly. Also, ensure that your laundry isn't too tightly packed inside the drum; spread it out evenly.
How to reduce excessive foam in Tornado TWV-FN710WTOA detergent drawer?
If you observe excessive foam in the detergent drawer of your Tornado Washer, it's likely due to using too much detergent or using the wrong type. To address this, press the Start/Pause button to pause the machine. Dilute one tablespoon of softener in 1/2 litre of water and pour it into the detergent drawer, then press the Start/Pause button again after 5-10 minutes. Ensure you only use detergents specifically produced for automatic washing machines.
Why Tornado TWV-FN710WTOA Washer gives unsatisfactory washing result?
If you're not satisfied with the washing results from your Tornado Washer, consider whether your laundry is too dirty for the selected program; refer to the program tables to choose a more appropriate one. Make sure you're using an adequate amount of detergent as instructed on the packaging. Also, avoid overloading the machine by ensuring you do not exceed the maximum capacity for the selected program.
How to improve washing result in Tornado TWV-FN710WTOA Washer with hard water?
If you're experiencing unsatisfactory washing results with your Tornado Washer, especially in areas with hard water, try increasing the amount of detergent according to the manufacturer's instructions. Also, ensure that your laundry is spread out in the drum and not too tightly packed.
What to do if Tornado Washer discharges water immediately after loading?
If your Tornado Washer immediately discharges water as soon as it's loaded, it's likely that the end of the water drain hose is positioned too low. Check that the drain hose is at a suitable height.
How to prevent grey spots on laundry washed in Tornado TWV-FN710WTOA?
If grey spots appear on your laundry after washing in your Tornado Washer, it indicates there is untreated oil, cream, or ointment on your laundry. For the next wash, use the amount of detergent as instructed on the packaging.
To Next Page
General