Toro 02611 HoverPro 550 - Adjusting Cutting Height; Cutting Height Adjustment Procedure

AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththeblade,causingseriousinjury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Weargloveswhilehandlingtheblade.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.
1.Turnthefuelswitchtotheoffposition.
2.Disconnectthewirefromthesparkplug.
3.Tiltthemachineonitsleftside.
4.Wearingprotectivegloves,removethebladebolt
andspacers.
5.Repositionthespacerstothedesiredheight,reinstall
thebladeretainerandspacers(Figure13,),andtighten
theboltto25N-m(18ft-lbs).
Figure13
1.Cutterbar
4.Bolt
2.Spacers
5.Largespacer
3.Bladeretainer
Note:Thelargespacermustbepositioneddirectly
belowtheimpelleratalltimes.
10