Toro 02611 HoverPro 550 - Engine Preparation; Filling Engine with Oil

2
InstallingtheFootstop
NoPartsRequired
Procedure
Securethefootstoptotheboltontherightsideofthelower
handleusinganutand2washers(Figure6).
Note:Installthefootstopusingthelowerholeinthe
footstopasshowninFigure6.
Figure6
1.Footstop4.Bolt
2.Nut5.Lowerhandle
3.Washer
3
FillingtheEnginewithOil
NoPartsRequired
Procedure
Important:Yourmachinedoesnotcomewithoilin
theengine.Beforestartingtheengine,lltheengine
withoil.
Max.ll:0.59L(20oz),type:SAE30orSAE10W-30
detergentoilwithanAPIserviceclassicationofSF,SG,SH,
SJ,SL,orhigher.
1.Movethemachinetoalevelsurface.
2.Removethedipstick(Figure7).
1
2
3
g017332
Figure7
1.Theoillevelisatits
maximum.
3.Theoillevelistoo
low—addoiltothe
crankcase.
2.Theoillevelistoo
high—removeoilfrom
thecrankcase.
3.Slowlypouroilintotheoilllhole,wait3minutes,
andchecktheoillevelonthedipstickbywipingthe
dipstickcleanandtheninserting,butnotscrewingin,
theoilllcapintothehole(Figure8).
g017338
Figure8
Note:Filltheenginecrankcasewithoiluntilthe
dipstickindicatesthattheengineoilleveliscorrect
asshowninFigure7.Ifyouoverlltheenginewith
oil,removetheexcessoilasdirectedinChangingthe
EngineOil(page15).
4.Installthedipstickandhandtightenitsecurely.
Important:
Change the engine oil after the r st 5
operating hour s ;changeityearlythereafter.Refer
toChangingtheEngineOil(page15).
7