Issued: 01.04.11 Approved: Mod. No. 5060358 Sheet 58 of 64 Part No. 111-4431 (A)
ROPS CAB, AIR CONDITIONING AND HEATING INSTALLATION - OPERATION
HEATER BLOWER ONLY:
1. Rotate the hot water valve mounted in the right hand side of
the roof console to achieve the desired air temperature.
Anti clockwise to increase temperature, clockwise in reduce
temperature.
2. The fan speed is controlled by the rocker switch on the left
hand side of the roof console.
3. The ve air vents in the roof console can be rotated and
angled to achieve the desired air direction.
4. Fig 88 shows the air conditioning controls which are only
tted with the air conditioning system.
AIR CONDITIONING ONLY:
(Initial start-up)
1. Close the hot water valve by rotating clockwise.
2. Start the engine.
3. Switch on the blower.
4. Set the cooling temperature control to maximum (fully
clockwise).
5. After 3 minutes cold air should come from the air outlet
vents.
6. Adjust fan speed and temperature control to the desired
setting.
Note: It is not advisable to combine minimum blower speed
with maximum thermostat cooling.
Do not operate the air conditioning without the engine
running as this will drain the battery.
Operation of the blower without the engine running
will result in air circulation with no air condition
cooling.
If the air conditioning system is not used for long
periods it is advisable to run the compressor for 15
minutes every 14 days (if outside temperature is at
least 5°C). This will help to prevent leaks from the
rotary shaft seals in the compressor.
Fig 88
To Next Page
Loading...
