Toro 03200 - Page 13

13
SET-UP INSTRUCTIONS
Figure 15
1. Lift cylinder
2. Hoses
3. Clearance here
1
2
3
7. Secure left end of lift cylinder to left lift arm with pin.
Secure with retaining ring.
Note: With lift arms fully raised, hoses should be
routed as shown in figure 15 and clear lift arm by
.04-.12".
MOUNT CARRIER FRAMES TO CUTTING
UNITS (Fig. 16 - 18)
1. Remove cutting units from cartons. Adjust per
Cutting Unit Operator's Manual.
2. Position a front carrier frame (Fig. 16) onto each
front cutting unit. Align mounting holes with mounting
links as shown in figure 18.
Figure 16
1. Front carrier frame
1
3. Position rear carrier frame (Fig. 17) onto rear
cutting unit, aligning mounting holes with mounting
links as shown in figure 18.
Figure 17
1
1. Rear carrier frame
4. Secure each mounting link to carrier frame with a
3/8-16 x 2-1/4" lg capscrew, (2) flatwashers and a
locknut, as shown in figure 18. Position a washer on
each side of link when mounting. Torque to 31 ft-lb.
Figure 18
1. Carrier frame
2. Mounting link
3. Plug
1
2
3
FRONT
MOUNT CUTTING UNITS (Fig. 19-21)
1. Slide a thrust washer onto each front lift arm pivot
rod.
2. Slide cutting unit carrier frame onto pivot rod and
secure with a lynch pin (Fig. 19).
Note: On rear cutting unit, thrust washer to be
positioned between rear of carrier frame and lynch pin.