Toro 03708N - Adjusting the Support Rollers; Installing the Cutting Units

1
AdjustingtheSupportRollers
NoPartsRequired
Procedure
Dependingonwhatwidthcuttingunitsaretobeinstalled
onthetraction,adjustthesupportrollersasfollows:
•Ifusing27inchcuttingunits,therollersaretobe
installedintheuppermountingholesofsupport
assemblychannels(
Figure3).
•Ifusing32inchcuttingunits,therollersaretobe
installedinthelowermountingholesofsupport
assemblychannels(Figure3).
g019541
1
2
3
Figure3
1.Supportassemblychannel3.Usethisholefor32inch
cuttingunits
2.Usethisholefor27inch
cuttingunits
2
InstallingtheCuttingUnits
Partsneededforthisprocedure:
1Fronthoseguide-R.H.
1Fronthoseguide-L.H.
Procedure
1.Removethereelmotorsfromtheshippingbrackets.
2.Removetheshippingbracketsanddiscard.
3.Removethecuttingunitsfromthecartons.Assemble
andadjustasdescribedinthecuttingunitOperator's
Manual.
4.Makesurethecounterweight(
Figure4)isinstalled
totheproperendofthecuttingunitasdescribedin
thecuttingunitOperator'sManual.
Figure4
1.Counterweight
5.Allthecuttingunitsareshippedwiththeturf
compensationspringmountedtotherightsideofthe
cuttingunit.Theturfcompensationspringmustbe
mountedtothesamesideofthecuttingunitasthe
reeldrivemotor.Repositiontheturfcompensation
asfollows:
A.Removethe2carriageboltsandnutssecuring
therodbrackettothecuttingunittabs(
Figure5).
Figure5
1.Turfcompensationspring3.Springtube
2.Rodbracket
B.Removetheangenutsecuringthespringtube
bolttothecarrierframetab(Figure5)Remove
theassembly.
C.Mountthespringtubebolttotheoppositetab
onthecarrierframeandsecurewiththeange
12