Figure 40
FRONT WHEEL TOE-IN
After every 600 operating hours or annually, check
front wheel toe-in.
1. Measure center-to-center distance (at axle
height) at front and rear of steering tires. Front
measurement must be equal to the rear measure-
ment 3mm.
2. To adjust, loosen jam nuts at both ends of tie rod.
Figure 42
1. Tie rod
3. Rotate tie rod to move front of tire inward or
outward.
4. Tighten tie rod jam nuts when adjustment is cor-
rect.
EMERGENCY BOX RAISING
(without starting the engine)
The box can be raised in an emergency by cranking
starter and holding lift lever. Run starter for 15 sec-
onds then wait 60 seconds before engaging starter
again.
If the engine will not crank, the load and box (attach-
ment) must be removed to service the engine or
transaxle.
FUSES
There are three fuses in the machine’s electrical sys-
tem. They are located under right side of dash panel.
FUSES
OPEN —
LIGHTS & HORN 10A
IGNITION
7.5A
DASH
7.5A
Figure 43
1. Fuse block
JUMP STARTING PROCEDURE
1. Loosen knobs securing battery cover to battery
base and slide cover off.
2. Connect a jumper cable between the positive
posts of the two batteries. The positive post may
37
Maintenance
Figure 41
Center-to-Center Distance
➀
To Next Page
Loading...
