EasyManuals Logo

Toro 08761 Installation Instructions

Toro 08761
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
Maintenance
Greasing the Attachment
If the locking lever on the attachment adapter does not
pivot freely and easily, apply a light coat of grease to the
area shown in figure 4.
Figure 4
Adjusting the Actuating Rod Springs
The springs and actuating rods are adjusted at the factory.
However, if new parts are installed or the springs are
removed for any reason, the spring length should be
adjusted to 5.24 inches (Fig. 5)
5.24”
Figure 5
Leveling the Finish Grader Blade
To level the blade in relation to the traction unit, place the
unit on a level surface (such as a concrete driveway), and
slightly vary the rear tire pressure as required.
Reversing the Scraper Blade
The scraper blade (Fig. 6) can be reversed for a second
wear surface after the original edge has worn beyond
acceptable limits.
1
Figure 6
1. Scraper blade
Optional Equipment
Weeder Tooth Scarifier Part No. 112–0260–03
Carbide Tipped Tooth Scarifier Part No. 110–0260–03
(15 required for each)

Other manuals for Toro 08761

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro 08761 and is the answer not in the manual?

Toro 08761 Specifications

General IconGeneral
BrandToro
Model08761
CategoryTractor
LanguageEnglish

Related product manuals