Toro 22297 - Installing the Recoil-Start Rope

3.Setthemachinetothedesiredcuttingheight;referto
AdjustingtheCuttingHeight(page11).
4.Standbehindthemachineintheoperatingpositionto
determinethehandleheightthatismostcomfortable
foryou(Figure4).
Figure4
1.Handle4.Mediumhandleheight
2.Handlebracket(2)
5.Lowesthandleheight
3.Highesthandleheight
5.Securethehandleontothehandlebracketsatyour
desiredhandleheightwith2carriagebolts(5/16x
1-1/2inches)and2angenuts(5/16inch)asshown
inFigure5.
Important:Ensurethattheboltheadsareon
theinsideofthehandleandthenutsareonthe
outsideofthehandle.
Figure5
1.Carriagebolt—5/16x
1-1/2inches(2)
3.Flangenut—5/16inch(2)
2.Handlebracket(2)
6.Positioneachcableguardontothehandlewiththe
cable(s)insidetheguard,andsecureeachtothehandle
withthe2carriageboltsandthe2locknutsthatyou
previouslyremoved(Figure3).
Important:Ensurethatyoudonotpinchthe
cable(s)tothehandlewithwhenyouinstallthe
cableguardsontothehandle.
2
InstallingtheRecoil-Start
Rope
NoPartsRequired
Procedure
Pulltherecoil-startropethroughtheropeguideonthe
handle(Figure6).
Figure6
1.Recoil-startrope2.Ropeguide
Note:Tomaketheropeeasiertoinstall,squeezethe
blade-controlbaronthehandle.
8