16
8. Lower cutting unit onto the flat surface. Remove the
covers from the top of the cutting units
9. Rotate the blade on each spindle until the ends face
forward and backward.
10. Measure from the floor to the front tip of the cutting
edge.
11. Adjust 1/8 in. shims on castor fork(s) to match height of
cut to decal (Fig. 18); refer to Adjusting the Cutting
Unit Pitch.
1
2
3
4
5
Figure 18
1. Castor wheel
2. Tensioning cap
3. Spacers
4. Shims
5. Axle mounting holes
To Next Page
Loading...
