8
Specifications
Specifications
Width of cut 62 in. or 72 in. width of cut, 3 blades.
Height of cut
1–5 in. (25–177 mm) adjustable in 1/2 in. (13 mm) increments. Height of cut adjust-
ment is achieved by changing spacers on castor wheels and length of height of cut rod.
Construction Housing is made of 7 gauge steel and reinforced with channels and plates.
Cutter drive
Isolation mounted gear box on cutting unit is driven by a PTO shaft. Power is
transmitted to the blades by one belt. Spindle shafts are supported by 2
greaseable, tapered roller bearings.
Blades Three 1/4 in. thick, heat-treated steel
Suspension and castor
wheels
Cutting unit has two front castors, consisting of 8 in. x 3.5 in. pneumatic wheel and
tire assembly with sealed ball bearings. Rear of cutting unit is suspended from lift
arms with adjustment links for cutting unit rake.
Anti-scalp features
Anti-scalp cup located on each blade. Anti-scalp rollers. Adjustable skid on each
end of cutting unit.
Cutting unit covers Steel covers
Note: Specifications subject to change without notice.
To Next Page
Loading...
