Groundsmaster 4100--D/4110--DPage 5 -- 16Electrical System
Cutting Deck Lift/Lower Problems (Continued)
Problem Possible Causes
LH wing cutting deck will not raise or lower, but the
front and RH wing cutting decks will raise and lower.
LH deck lift switch or circuit wiring is faulty.
Lift control manifold solenoid coils S2, S3 or S4 or
circuit wiring is faulty.
A hydraulic problem exists (see Troubleshooting
section of Chapter 4 - Hydraulic System).
TEC--5001 controller is faulty.
To Next Page
Loading...
