Toro 30582 - Page 10

10
106-0392
1. Engine—preheat
2. Fast
3. Continuous variable setting
4. Slow
5. Lower the cutting unit
6. Raise the cutting unit
7. Left cutting unit
8. Center cutting unit
9. Right cutting unit
95-0817
1. Low range height-of-cut
settings
2. High range height-of-cut
settings
105-0739
1. Read the Operator’s
Manual.
2. Grease every 50 hours.
3. Add grease (9 grease
points).
110–6126