7
Assembly
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Description Qty. Use
Upper handle section
Handle knobs
Oval-head bolts
Curved washers
1
2
2
2
Installing the handle
Locknuts
Washers
Knob
Discharge chute
2
2
1
1
Installing the discharge chute
Ignition key 1 Starting and stopping the engine
Power cord (electric-start model only) 1 Starting the engine
Installing the Handle
1. Position the ends of the upper handle section on the
inside of the lower handle section and align the holes
(Fig. 2).
m–4022
1
5
2
4
3
Figure 2
1. Handle knob (2)
2. Lower handle section
3. Oval-head bolt (2)
4. Upper handle section
5. Curved washer (2)
2. Insert the oval-head bolts into the aligned holes in the
handle sections with the bolt heads on the outside of the
handle (Fig. 2).
3. Install the curved washers and the handle knobs on the
oval-head bolts and tighten the handle knobs securely.
Note: Ensure that the oval-head bolts and the curved
washers are properly installed (See inset in Fig. 2).
Installing the Discharge Chute
1. Position the holes in the sides on the discharge chute
over the two hex bolts on the sides of the chute handle
(Fig. 3).
928
1
2
3
4
5
6
Figure 3
1. Discharge chute
2. Hex bolt (2)
3. Washer (2)
4. Chute handle
5. Knob
6. Locknut (2)
2. Secure the discharge chute onto the hex bolts with two
washers and two locknuts (Fig. 3).
3. Rotate the discharge chute to the upright position.
4. Install the knob tightly onto the screw at the rear of the
discharge chute (Fig. 3).
To Next Page
Loading...