Toro 38272 - Setup Procedures; Installing the Handle Assembly

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Oval-headbolts
2
Curvedwashers
2
1.
Handleknobs2
Installthehandle.
2.
Nopartsrequired
–
Installtherecoilstarterhandle.
Dischargechuteassembly1
Screws
2
Washers2
Locknuts2
3.
Knob1
Installthedischargechuteassembly.
4.
Bottleofengineoil
1Filltheenginewithoil.
Ignitionkey1
5.
Lanyard1
Assembleandinserttheignitionkey.
6.
Nopartsrequired
–
Adjustthecontrolcable.
1.InstallingtheHandle
2
Oval-headbolts
2
Curvedwashers
2Handleknobs
Procedure
1.Positiontheendsoftheupperhandleontheinside
ofthelowerhandleandaligntheholes.
2.Inserttheoval-headboltsintothealignedholes,
withtheboltheadsontheoutsideofthehandle
(Figure3).
Figure3
1.Oval-headbolt(2)2.Curvedwashersand
handleknobs
3.Installthecurvedwashersandthehandleknobs
ontheoval-headboltsontheinsideofthehandle
(Figure3)andtightentheknobssecurely.
Important:Ensurethatyoudonotpinchor
kinkthecontrolcable.
5