To Next PageTo Next Page
Need help?Do you have a question about the Toro 38458 and is the answer not in the manual?
General| Brand | Toro |
|---|---|
| Model | 38458 |
| Category | Snow Blower |
| Language | English |
Symbol indicating potential injury hazards.
Terms highlighting key information and general notes.
Crucial safety guidelines for operation and maintenance.
Safe practices for handling and storing gasoline.
Importance of reading manual and understanding controls.
Inspect area, appropriate clothing, and footwear.
Warnings about rotating blades causing injury.
Ensuring machine safety devices and fasteners are secure.
Emphasizes avoiding hand contact with rotating blades.
Steps to safely clear a clogged discharge chute.
Explains location, importance, and meaning of safety decals.
Identifies decals specific to different model numbers.
Chart to verify shipped parts for setup.
Steps to unfold and secure the handle.
Important note on not pinching control or Quick Shoot cables.
Steps to attach the discharge chute.
Caution against overtightening screws to prevent damage.
Specifies oil type, capacity, and steps for adding oil.
Labeled diagram identifying key machine parts.
Directs users to the maintenance section for adjustment.
Warning about flammability and explosion risk of gasoline.
Recommends unleaded gasoline and provides handling safety tips.
Specifies daily checks and outlines the steps to check oil.
Steps for turning key, setting choke, and using primer.
Caution against over-priming and details starting methods.
Cautions for electric starter use and overheating risks.
How to engage the rotor blades using the control bar.
How to disengage the rotor blades.
Turning the ignition key to stop the engine.
How to adjust discharge chute direction using controls.
How to adjust the chute deflector's angle.
Emphasizes hand safety and procedure to clear clogs.
Steps to prevent freezing of parts after operation.
Warning about objects being thrown by rotor blades.
Tips for efficient snow removal and machine handling.
Table outlining maintenance tasks by interval.
Procedure to check and adjust the control cable slack.
How to check rotor blades for wear using indicator holes.
Steps for draining and refilling engine oil.
Chart to select oil viscosity based on temperature.
Procedure for checking and replacing the spark plug.
Steps for installing and gapping the spark plug with safety notes.
When to replace the drive belt due to wear or damage.
Step-by-step instructions for replacing the drive belt.
How to check and adjust slack in the Quick Shoot cable.
Steps for adjusting cables and warning on over-tensioning.
Safety warnings and procedures for storing the machine.
Explains owner's rights and responsibilities for emissions warranty.
Details Toro's warranty for emission control systems.
Outlines owner's duty for maintenance and presenting the product.
Explains coverage for warranted emission-related parts.
Lists specific parts covered under the emission warranty.
Details engine start and product defect warranties.
Specifies commercial warranty and how to obtain service.
Emphasizes owner's maintenance role and general warranty terms.
