Toro 38517 CCR 3650 GTS - Product Overview and Setup; Component Identification; Handle Installation

5
3327-901
Product Overview
1
2
3
4
5
8
6
7
9
m-6230
1. Discharge chute
2. Chute crank
3. Control bar
4. Handle
5. Control panel
6. Knobs
7. Handle bolt (2)
8. Rotor blades
9. Fuel tank cap
1
2
3
4
m5544
1. Key switch
2. Primer
3. Recoil start
4. Choke lever
Setup
Installing the Handle
1. Cut the plastic tie that secures the control cable
to the handle.
2. Position the upper handle as shown.
m5516
3. Loosely
install the handle
bolts, curved
washers, and
knobs as shown.
m5573
4. Hook the end
of the control
cable into the
bottom hole of
the control bar.
m-5519
5. Fully insert the handle bolts.
Important:
Ensure that you
do not pinch the
control cable.
6. Tighten the
knobs until they
are snug.
m-6104
7. Adjust the control cable. Refer to Adjusting the
Control Cable on page 9.