SCAMP AND UTILITY MODELS
SERVICING
4502, 4503, 8602, 8603
WITH
“F”
SERIES ENGINES
SELF-PROPELLED BELT DRIVE
Adjustments
and
servicing of the Scamp and
Utility self-propelled mowers are very different
from
all
previous models of self-propelled
mowers.
SAFETY WARNING
BEFORE
ANY
ADJUSTMENTS OR
REPAIRS ARE ATTEMPTED, DIS-
CONNECT
AND
REMOVE SPARK
PLUG TO PREVENT STARTING.
INSTALLING CONTROL
ROD
1.
Place retainer clip on clutch arm
with
long side
of
clip on the inside
of
clutch arm.
2.
Align
hole in
clip
with
hole in arm and
assemble lower end
of
the control
rod
in
hole.
3.
Turn (swivel) long end
of
clip up and snap
into position on lower control rod as shown.
SAFETY WARNING
THE LOWER SELF PROPEL CON-
TROL ROD MUST
BE
ASSEMBLED
TO CLUTCH ARM
AS
SHOWN. IF
NOT THE SELF PROPEL MECH-
ANISM WILL NOT RETURN TO
NEUTRAL WHEN THE CONTROL
LEVER IS RELEASED FROM THE
ENGAGED POSITION.
10-44
REVISED
1983
SERVICE BULLETIN REFERENCES
To Next Page
Need help?
General
