Toro 500 EFI - Assembling Crankcase Half

112
GZ286A
GZ287
4. Install the outer reverse driven washer; then secure
the reverse driven gear assembly with a snap ring.
GZ288A
GZ314
5. Install the reverse driven gear dog onto the counter-
shaft and secure with a snap ring.
GZ313A
GZ312
6. From the opposite end of the countershaft, install the
high/low driven gear dog (A), thrust washer (B),
bushing (C), bearing (D), high/low driven gear (E),
and spacer washer (F).
GZ283B
7. Install the two drive gear washers and the shift forks.
The countershaft is now ready for installation.
NOTE: When installing the countershaft assembly,
account for the washer on each end of the shaft.
Assembling Crankcase
Half
1. Install the secondary drive gear assembly into the
crankcase.