Toro 51950A-250000001

Questions and Answers

C
cmejiaAug 15, 2025
What to do if the line won't advance on my Toro Trimmer?
- C
  Cynthia ClarkAug 15, 2025
  If the line on your Toro Trimmer won't advance automatically, there are several potential causes. The line might be welded to itself, in which case you should lubricate it with silicone spray. You may not have enough line on the spool, so try installing more line. If the line is worn too short, pull it while alternately pressing down on and releasing the retaining cap. The line could also be tangled on the spool; remove it and rewind it. Lastly, make sure the engine speed isn't too slow; advance the line at full throttle.
B
Brent MartinezAug 20, 2025
How to prevent grass from wrapping around the trimmer head of my Toro 51950A-250000001 Trimmer?
- C
  Cynthia ArnoldAug 20, 2025
  Grass can wrap around the trimmer head assembly and attachment shaft of your Toro Trimmer if you are cutting tall grass at ground level; try cutting tall grass from the top down. Also, ensure you are operating the product at full throttle, as operating at part throttle can contribute to this issue.
R
Ryan BowmanAug 26, 2025
Why does my Toro 51950A-250000001 engine emit excessive smoke and not reach full speed?
- S
  Sabrina SandersAug 26, 2025
  If your Toro Trimmer engine isn't reaching full speed and is emitting excessive smoke, you should first check the oil/fuel mixture, ensuring you're using fresh fuel and the correct 2-cycle oil mix. Also, inspect the air filter and clean it if it's dirty. Finally, examine the spark arrestor screen and clean it if necessary.
M
Marissa HammondAug 29, 2025
Why is oil dripping from the muffler of my Toro 51950A-250000001 Trimmer?
- J
  Jason MartinezAug 29, 2025
  Oil may drip from the muffler of your Toro Trimmer due to several reasons. Ensure you are operating the product at full throttle. Also, verify the oil/fuel mixture, using fresh fuel and the correct 2-cycle oil mix. Lastly, a dirty air filter can cause this issue, so clean the air filter.
M
Melissa CurtisSep 3, 2025
What to do if the retaining cap is hard to turn on my Toro 51950A-250000001?
- C
  Connie VargasSep 4, 2025
  If the retaining cap on your Toro Trimmer is hard to turn when using automatic line lengthening, the screw threads may be dirty or damaged. Clean the threads and lubricate them with grease. If this doesn't solve the problem, you may need to replace the retaining cap.
B
Brittany WoodNov 9, 2025
Why won't my Toro Trimmer engine start?
- S
  Sharon ButlerNov 9, 2025
  If your Toro Trimmer engine won't start, it could be due to several reasons. First, ensure the switch is in the I (ON) position. If it is, check for a spark by removing the spark plug, reattaching the cap, and laying it on the metal cylinder while pulling the starter cord. If there's no spark, try a new spark plug. Also, make sure the primer bulb is full of fuel; if not, the fuel delivery system may be blocked. If the engine is flooded, remove the spark plug, turn the product so that the spark plug hole is aimed at the ground, ensure the start lever is set to RUN, and pull the starter cord 10 to 14 times to clear excess fuel. Clean and reinstall the spark plug. With the trigger fully depressed, pull the starter cord 3 times. If the engine does not start, set the start lever to START and fo...

Toro 51950A-250000001 Specifications

General

Power Source	Gas
Cutting Width	17 inches
Line Diameter	0.095 inches
Corded/Cordless	Cordless
Engine Type	2-cycle
Engine Displacement	25.4 cc
Shaft Type	Straight
Weight	10.5 lbs
Cutting System	Bump feed