For long term storage, either drain gasoline from
fuel tank or use a fuel additive before storing. To
drain gasoline, refer to Draining Gasoline From Fuel
Tank, page 21. After fuel is drained, start engine and
let it idle until all fuel is consumed and engine stops.
Repeat the starting procedure two more times to asĆ
sure all gas is removed from the engine. If gasoline
is not drained, gum-like varnish deposits will form
and cause poor engine operation, even starting
problems.
Fuel can be left in gas tank only if a fuel additive,
such as Toro's Stabilizer/Conditioner, is added to
gasoline before storing. Toro's Stabilizer/Conditioner
is a petroleum distillate based conditioner/stabilizer.
Toro does not recommend stabilizers with an alcohol
base, such as ethanol, methanol or isopropyl. Use
fuel additive in recommended quantities as specified
on container.
Under normal conditions, fuel additives remain effecĆ
tive in fuel for 6-8 months.
. Remove wire from spark plug and clean area
around the plug so foreign matter cannot fall into cylinĆ
der when plug is removed. Next, remove plug from cylĆ
inder head and pour two tablespoons of engine oil into
spark plug hole. Rotate engine by hand to distribute oil
on inside of cylinder. Then reinstall spark plug and
tighten it to 20 ftĆlb. If torque wrench is not used, tightĆ
en plug firmly. DO NOT REINSTALL WIRE ON SPARK
PLUG.
Drain oil from crankcase: refer to Changing CrankĆ
case Oil, page 20. However, do not fill crankcase with
oil at this time.
. Remove battery from chassis: refer to Activating
and Charging Battery, page 11. Remove corrosion
from battery terminal and wipe any grease and dirt off
the battery case. Check level of electrolyte. If level is
low, add distilled water to the affected cell. Fill only to
the fill ring below the filler cap. Reinstall filler caps.
Clean dirt and chaff from outside of cylinder, cylinĆ
der head fins, and blower housing. Also, remove grass
clippings, dirt, and grime from external parts of rider,
engine, shrouding, and top of mower housing.
. Clean underside of mower housing: refer to CleanĆ
ing Underside of Mower Housing, page NO TAG.
Check condition of blade: refer to Servicing Cutter
Blade, page 22.
Check and tighten all cap screws, bolts, screws,
nuts, and mating parts. If any part is damaged, repair
or replace it.
Lubricate wheels and spindles with grease: refer to
Grease Front Axle Spindles and Wheels, page 19.
Remove dust and dirt from air cleaner element: reĆ
fer to Servicing Air Cleaner, page 20.
Touch up all rusted or chipped paint surfaces.
Make sure to sand affected area before painting.
&* TORO ReĆKote touchĆup" paint is available from
any Authorized TORO Service Dealer. The spray paint
dries in minutes to a glossy, factoryĆfinish.
. Fill crankcase with oil: refer to Fill Crankcase With
Oil, page 12.
. Install the battery: refer to Activating and Charging
Battery, page 11. Charge battery for 48 hours to assure
full charge.
%'(&'( )*&(! &( #$+( *& (-
"(! %, +) **(, #$+(
. Store the rider in a clean, dry garage or storage
area. Remove key from ignition switch and keep it in a
memorable place. Cover the rider to protect it and keep
it clean.
To Next Page
Loading...
