.'%%/ 0. 00,+ +%'+# Four cycle engine has
output of 8 hp (6 KW) @ 3600 rpm and 12.7 ft/lb
(17.2 N·m) torque @ 2500 rpm. Displacement is
19.44 cubic inches (319 cc). Crankcase oil capacity
is approximately 36 oz. (1.06 l). Correct spark plug is
a Champion RJĆ19LM. Recommended spark plug air
gap is 0.030 of an inch (0.762 mm).
,3#. ,1/'+% Full floating, stamped steel housĆ
ing has spiral grass chamber, kickers, cover and
ring. Width of cut is 25 inches (63.5 cm). Cast iron
spindle housing with shaft is supported by sealed
ball bearings. Blade pulley is driven by a belt from
the engine pulley.
100#. ) "# Single blade is 25 inches (63.5 cm)
long, made of 7 gauge (2.72 mm) carbon steel and
heat treated for hardness.
) "# '- -##" Tip speed of blade is 17,420 ft/
min @ 3400 engine rpm.
#'%&0,$10 +%# Adjustable to five approxiĆ
mate range settings: 1-1/2 inches to 3-1/2 inches.
. +/*'//',+ Transmission has five speeds forward
and one for reverse. Heat treated, sintered metal
gears are enclosed in a permanently lubricated (EP
Lithium grease), die cast aluminum housing.
'$$#.#+0' ) Sintered powdered metal bevel gears
are enclosed in a permanently lubricated (Shell Epro
71030 grease), steel housing.
. !0',+ .'2# Drive system has an A" section v-
belt from engine pulley to transmission input pulley.
A no. 40 chain joins transmission output sprocket
with differential sprocket.
.,1+" -##" +%'+# .-*
1st gear - 1.4 mph
2nd gear - 2.1 mph
3rd gear - 3.2 mph
4th gear - 4.1 mph
5th gear - 4.7 mph
Rev. - 1.6 mph
&##)/ +" '.#/ The front 11 x 4.00Ć5 and the rear
13 x 5.00Ć6 tubeless, pneumatic turf tires are
installed on demountable stamped steel wheels.
Recommended pressure for front and rear tires is
10-14 psi. All tires must be equally inflated to enĆ
sure a level cut.
1#) +( Capacity is 4 quarts (3.7 l).
0##.'+% 13 inch (33 cm) diameter steering wheel.
&.,00)# ,+0.,) Control is located on right side of
seat body. Hand-operated throttle control connects
to and operates carburetor-mounted throttle and
choke. Control has three positions: SLOW, FAST
AND CHOKE.
. +/*'//',+ # . &'$0 Single lever, in-line shiftĆ
ing with Z pattern.
)10!& #" ) Foot-operated pedal is located at left
front side of rider. Depressing clutch pedal moves
idler pulley away from traction drive belt, which disĆ
engages the traction drive.
. (# #" ) Foot operated pedal is located at right
front side of rider. Depressing brake pedal engages
a disk brake on side of transmission.
.('+% . (# ,+0.,) Control is located at right
front of center channel. Engage parking brake by
moving control to the left while brake pedal is deĆ
pressed; then release pedal. To disengage parking
brake, push brake pedal down so parking brake leĆ
ver moves back to its normal released position.
) "# ,+0.,) Control is mounted on front of seat
body. Control has two positions: ENGAGE and DISĆ
ENGAGE. Interlock switch prevents engine from
starting when control is in the ENGAGED position.
When control is in DISENGAGE position, the blade
brake is applied and blade belt idler pulley is disenĆ
gaged. By contrast, idler pulley is engaged with
blade belt when control is in the ENGAGE position:
blade brake is released.
%+'0',+ 3'0!& Switch is located on right side of
seat body. Switch has three positions: ON, OFF and
START.
#'%&05$510 ,+0.,) Control is mounted on front
of seat body.
#+#. ) '*#+/',+/ --.,4
Wheel Base -41 in (104 cm)
Wheel Tread -28 in (71 cm) front outside to outĆ
side
Overall Length -52 in (132 cm)
Overall Height -38 in (.97 m)
Overall Width -32 in (81 cm)
Dry Weight -305 Ib (1.6 kg)
Specifications and design subject to change without notice.
To Next Page
Loading...
