10
106-1802
1. Warning—read the
Operator’s Manual.
2. Cutting hazard of hand—remove the ignition key and read the
instructions before servicing or performing maintenance.
3. Thrown object hazard—keep bystanders a safe distance from
the machine.
4. Tipping hazard—do not drive up a slope greater than 10
degrees.
106-2943
1. Thrown object and cutting hazards—do not operate the
machine with the discharge opening uncovered; always
operate the machine with the recycling cover, rear discharge
deflector, or grass collector installed.
Molded into the floor near the brake pedal
1. Brake
Molded into the floor near the parking brake lever
1. Parking brake
Molded into the floor near the traction control
pedal
1. Forward
Molded into the floor near the traction control
pedal
1. Neutral
Molded into the floor near the traction control
pedal
1. Reverse
Molded into the body near the throttle control
lever
1. Fast
2. Slow
3. Choke
Molded into the body near the ignition switch
1. Engine
To Next Page
Loading...
