Toro 724 - Loose Parts; Cotter Pin and Flat Washer; Capscrews & Curved Washers; Clevis Pin and Flange Nut

7
Loose Parts
DESCRIPTION QTY. USE
Cotter Pin
Flat Washer
1
1
Install on Speed Selector Rod
Capscrews & Curved Washers 4 Install Handle
Clevis Pin
Cotter Pin
Flange Nut
1
1
2
Install Auger & Traction Drive Control Rod
Capscrew & Locknut
Locknut & Pyramidal Washer
1
1
Install Chute Control Rod
Flange Head Capscrew 1 Connect Wires
Carriage Bolt
Rubber Washer
Friction Plate
Large Flat Washer
Curved Washer
Locknut
1
1
1
1
1
1
Secure Chute Deflector
Key 1 Use in Ignition Switch
Registration Card 1 Used to Validate Product Warranty
Accessories
DESCRIPTION PART NUMBER
110 Vac Electric Starter Kit 38037
Tire Chain Kit 56–2700
Drift Breaker Kit 37–7021
Assembly
Note: Determine left and right sides of
snowthrower by standing in the normal
operating position.
Install Handle
1. Remove tie straps securing control rods to
handle.