Toro 74167 User Manual (English)

Other manuals for Toro 74167

Questions and Answers:

J
jennifer31Aug 4, 2025
Why won't my Toro Mower engine start?
- S
  Sarah SchultzAug 4, 2025
  If your Toro Mower's engine won't start, starts hard, or struggles to keep running, several factors could be at play. Ensure the fuel tank is filled with gasoline and the fuel valve is open. Check that the choke is activated. A dirty air cleaner can also cause issues, so clean or replace it. Inspect the spark plug wires and make sure they are properly connected. Replace any pitted, fouled, or incorrectly gapped spark plugs. Lastly, check the fuel filter for dirt and replace if necessary. If the problem persists, there might be dirt, water, or stale fuel in the fuel system, in which case you should contact an authorized service dealer.
J
Jason SantosAug 8, 2025
How to fix a Toro Mower when the starter does not crank?
- T
  Thomas MillerAug 8, 2025
  If the starter on your Toro Mower doesn't crank, make sure the blade control (PTO) is disengaged and the parking brake is set. Ensure you are seated on the seat. A dead battery can also prevent the starter from cranking, so charge the battery. Check for corroded or loose electrical connections and ensure they have good contact. Replace any blown fuses. If none of these steps work, the relay or switch may be defective, and you should contact an authorized service dealer.
S
Sarah MendozaAug 13, 2025
What to do if the blades on my Toro Mower do not rotate?
- K
  Kristen AdkinsAug 13, 2025
  If the blades on your Toro Mower are not rotating, ensure the mower belt is properly installed on the pulley, checking the adjusting plate, idler arm and spring, and belt guides for correct positioning. If the mower belt is worn, loose, or broken, replace it with a new one. If the electric clutch does not engage or is worn, contact an authorized service dealer.
R
Robert AlvaradoAug 17, 2025
What to do if my Toro Mower engine loses power?
- S
  staceyholmesAug 17, 2025
  If your Toro Mower engine is losing power, try reducing your ground speed, as the engine load may be excessive. Clean the air cleaner element. Check the oil level in the crankcase and add oil if it's low. Also, remove any obstructions from the cooling fins and air passages under the engine blower housing. Replace any pitted, fouled, or incorrectly gapped spark plugs. Replace the fuel filter if it's dirty. If the issue continues, there may be dirt, water, or stale fuel in the fuel system, so contact an authorized service dealer.
R
reedrhondaAug 22, 2025
Why is my Toro Mower engine overheating?
- B
  Brooke JacksonAug 22, 2025
  If your Toro Mower engine overheats, begin by reducing the ground speed, as the engine load may be excessive. Check the oil level in the crankcase and add oil if it is low. Ensure that the cooling fins and air passages under the engine blower housing are free of obstructions.
B
Brandon SanchezAug 26, 2025
How to stop abnormal vibration in my Toro Mower?
- C
  Catherine GrantAug 26, 2025
  If your Toro Mower is producing an abnormal vibration, start by tightening the engine mounting bolts. Next, tighten any loose engine pulley, idler pulley, or blade pulley. If any engine pulley is damaged, contact an authorized service dealer. Install new cutting blades if the current ones are bent or unbalanced. Ensure the blade mounting bolt is tightened. If the blade spindle is bent, contact an authorized service dealer.
Y
ymaxwellAug 30, 2025
Why is my Toro Mower cutting unevenly?
- K
  Katelyn OrtizAug 30, 2025
  If your Toro Mower is providing an uneven cutting height, start by sharpening the blades. Replace the cutting blades if they are bent. Ensure the mower is level from side-to-side and front-to-rear. Adjust the gage wheel height as needed. Clean the underside of the mower deck. Adjust the tire pressure to the correct level. If the blade spindle is bent, contact an authorized service dealer.