EasyManua.ls Logo

Toro 74386 - User Manual

Toro 74386
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3375-707RevA
TimeCutter
®
ZS4200or5000
RidingMower
ModelNo.74386—SerialNo.313000001andUp
ModelNo.74387—SerialNo.313000001andUp
Registeratwww.Toro.com.
OriginalInstructions(EN)
*3375-707*A

Table of Contents

Questions and Answers

  • D
    daltonbakerAug 16, 2025
    Why won't my Toro Lawn Mower engine start?
    • H
      hilljasmineAug 17, 2025
      Several factors can prevent your Toro Lawn Mower engine from starting. First, ensure the fuel tank isn't empty by filling it. If it is not the reason, make sure the choke is on. A dirty air cleaner can also be the culprit, so clean or replace it. Check that the spark plug wire(s) is securely connected to the spark plug. Inspect the spark plug(s) for damage, and replace if needed. Additionally, ensure the fuel filter is clean, and the fuel tank contains the correct type of fuel. Finally, check that the oil level in the crankcase is sufficient and add oil if needed.
  • L
    lori06Aug 19, 2025
    Why does my Toro 74386 Lawn Mower engine lose power?
    • C
      Christopher ShahAug 20, 2025
      If your Toro Lawn Mower engine is losing power, consider these possible causes: The engine load might be excessive, so reduce ground speed. A dirty air cleaner can also cause power loss, so clean the air cleaner element. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages under the engine blower housing are free from obstructions. Inspect the spark plug(s) and replace them if pitted, fouled, or incorrectly gapped. Finally, if there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type.
  • S
    Sarah BrownAug 22, 2025
    What to do if my Toro Lawn Mower starter does not crank?
    • C
      Cheryl WrightAug 22, 2025
      If the starter on your Toro Lawn Mower isn't cranking, try these steps: Ensure the blade control switch is disengaged. Verify that the motion control levers are in the park position. If the battery is dead, charge it. Check the electrical connections for corrosion or looseness, ensuring good contact. Finally, inspect the fuse and replace it if blown.
  • D
    Daniel WilliamsAug 26, 2025
    How to fix uneven cutting height on Toro 74386 Lawn Mower?
    • M
      mitchelljerryAug 26, 2025
      To correct uneven cutting height on your Toro Lawn Mower, consider these factors: Sharpen the blade(s) if they are not sharp. Replace any bent cutting blade(s). Level the mower from side-to-side and front-to-rear. Adjust the anti-scalp wheel height if it's not set correctly. Clean the underside of the mower if it's dirty. Adjust the tire pressure to the correct level.
  • L
    Lori PorterAug 28, 2025
    What to do if the blades on my Toro 74386 do not rotate?
    • C
      cgutierrezAug 28, 2025
      If the blades on your Toro Lawn Mower aren't rotating, check if the drive belt is worn, loose, or broken, and install a new drive belt if necessary. Also, ensure the drive belt is properly positioned on the pulley, and check the adjusting shafts and belt guides for correct positioning. Finally, check if the mower belt is worn, loose, or broken and install a new mower belt if needed.
  • D
    Danielle WardAug 31, 2025
    How to troubleshoot uneven cutting height on my Toro Lawn Mower?
    • A
      April BarnettAug 31, 2025
      Uneven cutting height on your Toro Lawn Mower can be caused by several factors. Ensure the blade(s) is sharp, and sharpen them if necessary. If a cutting blade(s) is bent, install a new one. Make sure the mower is level from side-to-side and front-to-rear. Check that the anti-scalp wheel is set correctly and adjust its height if needed. Clean the underside of the mower if it's dirty. Also, ensure the tire pressure is correct and adjust it accordingly.
  • B
    brandygriffinSep 3, 2025
    How to fix Toro Lawn Mower when the engine overheats?
    • J
      Jacob PayneSep 3, 2025
      If your Toro Lawn Mower's engine is overheating, there are several potential causes. First, reduce ground speed if the engine load is excessive. Check the oil level in the crankcase and add oil if it's low. Inspect the cooling fins and air passages under the engine blower housing for obstructions and remove them. Also, make sure that the air cleaner is not dirty; clean or replace the air cleaner element if necessary.
  • K
    Kelly BlairSep 6, 2025
    How to stop abnormal vibration in my Toro 74386 Lawn Mower?
    • S
      Stephanie BurnsSep 6, 2025
      To address abnormal vibration in your Toro Lawn Mower, check the following: Tighten any loose engine mounting bolts. Ensure the engine pulley, idler pulley, or blade pulley are tightened appropriately. Replace the cutting blade(s) if they are bent or unbalanced. Also, tighten any loose blade mounting bolts.
  • H
    Heather CarterSep 9, 2025
    What to do if Toro 74386 starter does not crank?
    • D
      David ClarkSep 9, 2025
      If the starter on your Toro Lawn Mower doesn't crank, it could be due to a few reasons. Ensure the blade control switch is disengaged. Also, make sure the motion control levers are in the park position. The battery might be dead, so charge it. Check the electrical connections for corrosion or looseness and ensure good contact. Finally, a fuse might be blown, so replace it.
  • M
    Melissa PhamSep 12, 2025
    Why is my Toro 74386 Lawn Mower vibrating abnormally?
    • I
      Ian PatelSep 13, 2025
      Abnormal vibration in your Toro Lawn Mower can stem from several issues. Check if the engine mounting bolts are loose and tighten them. Ensure the engine pulley, idler pulley, or blade pulley is not loose and tighten the appropriate pulley. The cutting blade(s) could be bent or unbalanced, so install a new cutting blade(s). Also, verify that the blade mounting bolt is not loose, and tighten it if necessary.

Toro 74386 Specifications

General IconGeneral
Model74386
Engine Displacement163 cc
Deck MaterialSteel
Mulching CapabilityYes
Bagging CapabilityYes
Side Discharge CapabilityYes
Engine Type4-Cycle
Starting SystemRecoil
Cutting Width22 inches
Drive TypeSelf Propelled
Cutting Height1.25 to 4 inches
Mulch, Bag, Side DischargeBag, Mulch, Side Discharge
Fuel Tank Capacity0.25 gallons

Related product manuals