EasyManua.ls Logo

Toro 74410 - Stopping the Engine

Toro 74410
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure13
1.PTO—on2.PTO—off
4.Movethechokecontroltotheonpositionbefore
startingacoldengine(Figure14).
Note:Awarmorhotenginemaynotrequire
choking.Afterenginestarts,movechokecontrolto
Runposition.
Figure14
1.Choke—on2.Choke—off
5.MovethethrottlecontroltotheFastposition
beforestartingacoldengine(Figure15).
Figure15
1.Throttle—fast
2.Throttle—slow
6.TurntheignitionkeytoStart.Whentheengines
starts,releasethekey(Figure16).
Important:Donotengagestarterformore
than10secondsatatime.Ifenginefailsto
startallow30secondcool-downperiodbetween
attempts.Failuretofollowtheseinstructions
canburnoutstartermotor.
Figure16
1.Off3.Start
2.Run
7.Aftertheenginestarts,movethechoketooff
(Figure14).Iftheenginestallsorhesitates,move
thechokebacktoonforafewseconds,thenmove
thethrottlelevertodesiredsetting.Repeatthisas
required.
StoppingtheEngine
1.PushthePTOtotheoffposition(Figure13).
2.Movethethrottlelevermidwaybetweentheslow
andfastpositions(Figure15).
3.Lettheengineidlefor60seconds.
4.Turntheignitionkeytotheoffpositionandremove
thekey(Figure16).
5.Closethefuelshutoffvalvebeforetransporting
orstoringthemachine.
Important:Makesurethatthefuelshutoff
valveisclosedbeforetransportingorstoring
themachine,asfuelleakagemayoccur.Setthe
parkingbrakebeforetransporting.Makesure
16

Table of Contents

Related product manuals