Why Toro 74418 Lawn Mower engine will not start?
If your Toro Lawn Mower engine won't start, starts hard, or fails to keep running, here are a few things to check: * **Fuel Tank:** Ensure the fuel tank is filled with fuel. * **Air Cleaner:** A dirty air cleaner can cause problems, so clean or replace the air cleaner element. * **Fuel Filter:** Check for dirt in the fuel filter and replace it if necessary.
What to do if Toro 74418 Lawn Mower blades do not rotate?
If the blades on your Toro Lawn Mower do not rotate, check these items: * **Drive Belt:** Check the belt tension if the drive belt is worn, loose, or broken. Install the drive belt and check adjusting shafts and belt guides for correct position if the drive belt is off the pulley. * **Deck Belt:** Install a new deck belt if the deck belt is worn, loose, or broken. Install the deck pulley and check the idler pulley, idler arm and spring for correct position and function if the deck belt is off the pulley. * **Idler Spring:** Replace the spring if the idler spring is broken or missing.
Why Toro 74418 engine loses power?
If your Toro Lawn Mower engine loses power, consider these potential causes: * **Engine Load:** Reduce the ground speed if the engine load is excessive. * **Air Cleaner:** Clean the air cleaner element if it's dirty. * **Oil Level:** Add oil to the crankcase if the oil level is low. * **Cooling Fins and Air Passages:** Remove any obstructions from the cooling fins and air passages above the engine. * **Fuel Cap:** Clean or replace the fuel cap if the vent hole is plugged. * **Fuel Filter:** Replace the fuel filter if it's dirty.
How to fix uneven cutting height on Toro 74418?
If your Toro Lawn Mower is producing an uneven cutting height, consider the following: * **Blades:** Sharpen the blades if they are not sharp, or install new cutting blade(s) if they are bent. * **Mower Level:** Level the mower from side-to-side and front-to-rear. * **Mower Underside:** Clean the underside of the mower if it's dirty. * **Tire Pressure:** Adjust the tire pressure to the correct level.
What to do if Toro 74418 Lawn Mower starter does not crank?
If the starter on your Toro Lawn Mower doesn't crank, consider the following: 1. **Blade Control (PTO):** Ensure the blade control is disengaged. 2. **Parking Brake:** Make sure the parking brake is set. 3. **Operator Presence:** Confirm someone is sitting on the seat. 4. **Battery:** Check if the battery is dead; if so, charge it. 5. **Electrical Connections:** Inspect electrical connections for corrosion or looseness and ensure good contact. 6. **Fuse:** Verify the fuse isn't blown; replace it if necessary.
How to fix Toro Lawn Mower engine overheating?
If your Toro Lawn Mower engine overheats, consider these potential causes: * **Engine Load:** Reduce the ground speed if the engine load is excessive. * **Oil Level:** Add oil to the crankcase if the oil level is low. * **Cooling Fins and Air Passages:** Remove any obstructions from the cooling fins and air passages above the engine.
Why does my Toro 74418 have abnormal vibration?
If you notice abnormal vibration in your Toro Lawn Mower, here's what you should check: * **Cutting Blades:** Bent or unbalanced cutting blades can cause vibration. Install new cutting blade(s). * **Blade Mounting Bolt:** Ensure the blade mounting bolt is tightened. * **Engine Mounting Bolts:** Tighten the engine mounting bolts. * **Pulleys:** Check and tighten any loose engine pulleys, idler pulleys, or blade pulleys.
What to do if Toro 74418 Lawn Mower does not drive?
If your Toro Lawn Mower does not drive, check the following: * **Bypass Valve:** Tighten the bypass valve to ensure it's closed tight. * **Drive or Pump Belt:** Change the belt if the drive or pump belt is worn, loose, or broken. Also, change the belt if it is off a pulley. * **Idler Spring:** Replace the spring if the idler spring is broken or missing. * **Hydraulic Fluid:** Add hydraulic fluid to the reservoir or let it cool down if the hydraulic fluid level is low or too hot.
General| Brand | Toro |
|---|---|
| Model | 74418 |
| Category | Lawn Mower |
| Language | English |
Test the safety interlock system before you use the machine each time.
Lists maintenance tasks and service intervals for the machine.
Details on cleaning and replacing foam and paper air cleaner elements.
Procedure for checking engine oil level before each use or daily.
Steps for changing engine oil after initial use and every 100 hours.
Procedure for replacing the fuel filter after every 200 operating hours or yearly.
Instructions for changing the hydraulic filter and oil annually.
Troubleshooting steps for when the starter motor does not crank.
Troubleshooting steps for engine starting and running issues.
To Next Page
