EasyManua.ls Logo

Toro 74415 - Changing the Oil; Changing the Oil Filter

Toro 74415
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important: Do not o v erfill the crankcase
with oil and r un the engine; engine dama ge
can r esult.
Changing the Oil
1. Star t the engine and let it r un fiv e min utes .
T his w ar ms the oil so it drains better .
2. P ark the mac hine so that the drain side is
slightly lo w er than the opposite side to assure
the oil drains completely .
3. Diseng ag e the PTO and set the parking brak e .
4. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
5. Slide the drain hose o v er the oil drain v alv e .
6. Place a pan belo w the drain hose . R otate oil
drain v alv e to allo w oil to drain ( Figure 35 ).
7. W hen oil has drained completely , close the
drain v alv e .
8. R emo v e the drain hose ( Figure 35 ).
Note: Dispose of the used oil at a recycling
center .
Figure 35
1. Oil drain valve 2. Oil drain hose
9. Slo wly pour appro ximately 80% of the
specified oil into the filler tube ( Figure 34 ).
10. Chec k the oil lev el; refer to Chec king the
Engine Oil Lev el.
11. Slo wly add the additional oil to bring it to the
Full mark.
Changing the Oil Filter
R e place the oil filter ev er y 200 operating hours or
ev er y other oil c hang e .
Note: Chang e the oil filter more frequently when
the operating conditions are extremely dusty or
sandy .
1. Drain the oil from the engine; refer to
Changing the Engine Oil.
2. R emo v e the old filter ( Figure 36 ).
Figure 36
1. Oil lter 2. Adapter
3. Apply a thin coat of new oil to the r ubber
g ask et on the re placement filter ( Figure 36 ).
4. Install the re placement oil filter to the filter
adapter , tur n the oil filter cloc kwise until
the r ubber g ask et contacts the filter adapter ,
then tighten the filter an additional 3/4 tur n
( Figure 36 ).
5. Fill the crankcase with the proper type of new
oil; refer to Ser vicing the Engine Oil.
6. R un the engine for about 3 min utes , stop the
engine , and c hec k for oil leaks around the oil
filter .
7. Chec k the engine oil lev el and add oil if needed.
32

Table of Contents

Related product manuals