EasyManua.ls Logo

Toro 74675 - User Manual

Toro 74675
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3393-656RevA
TimeCutter
®
SW4200orSW5000
RidingMower
ModelNo.74675—SerialNo.315000001andUp
ModelNo.74680—SerialNo.315000001andUp
g027698
Registeratwww.Toro.com.
OriginalInstructions(EN)
*3393-656*A

Table of Contents

Questions and Answers

  • S
    sbennettSep 13, 2025
    What causes abnormal vibration in my Toro 74675 Lawn Mower?
    • R
      rita21Sep 13, 2025
      Abnormal vibration in your Toro Lawn Mower could be caused by loose engine mounting bolts; tighten them. Check if the engine pulley, idler pulley, or blade pulley is loose and tighten the appropriate pulley. If the engine pulley is damaged or a blade spindle is bent, it is recommended to contact an Authorized Service Dealer. Other potential causes include bent or unbalanced cutting blades (install new cutting blade(s)) or a loose blade mounting bolt (tighten the blade mounting bolt).
  • S
    Susan HudsonSep 12, 2025
    What to do if the Toro 74675 starter does not crank?
    • G
      Gary ReedSep 12, 2025
      If the starter on your Toro Lawn Mower isn't cranking, first ensure the blade control switch is disengaged. If it's already disengaged, the battery may be dead, so charge it. Check the electrical connections for corrosion or looseness and ensure they have good contact. Also, inspect the fuse and replace it if it's blown. In case a relay or switch is damaged, it is recommended to contact an Authorized Service Dealer.
  • H
    Hannah PinedaSep 12, 2025
    Why is my Toro Lawn Mower vibrating abnormally?
    • A
      awrightSep 12, 2025
      If you're experiencing abnormal vibration with your Toro Lawn Mower, here are some things to inspect: 1. Check if the engine mounting bolts are loose and tighten them. 2. Ensure the engine pulley, idler pulley, or blade pulley is not loose and tighten the appropriate pulley. 3. If the cutting blade(s) is/are bent or unbalanced, install a new cutting blade(s). 4. Also, make sure the blade mounting bolt is tightened.
  • S
    Stephanie TurnerSep 12, 2025
    What to do if my Toro 74675 starter does not crank?
    • E
      Evan LesterSep 12, 2025
      If the starter on your Toro Lawn Mower isn't cranking, here are a few things to check: 1. Ensure the blade-control switch is disengaged. 2. The battery might be dead, so charge it. 3. Check the electrical connections for corrosion or looseness and ensure they have good contact. 4. A blown fuse could also be the culprit, so replace it.
  • K
    Kathy DavisSep 9, 2025
    How to fix Toro Lawn Mower when the engine overheats?
    • J
      Justin KrauseSep 10, 2025
      If your Toro Lawn Mower engine is overheating, several factors could be the cause. First, the engine load may be excessive, so reduce your ground speed. Second, the oil level in the crankcase may be low, so add oil. Third, the cooling fins and air passages under the engine blower housing may be obstructed, so remove any obstructions. Lastly, the air cleaner might be dirty, so clean or replace it.
  • L
    lawrenceericaSep 8, 2025
    What to do if the blades do not rotate on my Toro 74675?
    • K
      kvasquezSep 9, 2025
      If the blades on your Toro Lawn Mower do not rotate, install a new drive belt if the current one is worn, loose, or broken. If the drive belt is off of the pulley, install it, ensuring the adjusting shafts and belt guides are in the correct position. If the power takeoff (PTO) switch or PTO clutch is faulty, contact an Authorized Service Dealer. Install a new mower belt if the current one is worn, loose, or broken.
  • A
    Ashley ScottSep 7, 2025
    Why Toro Lawn Mower engine loses power?
    • T
      Tammy SchultzSep 7, 2025
      If your Toro Lawn Mower engine is losing power, several factors could be responsible. The engine load might be too high, so try reducing the ground speed. A dirty air cleaner can also cause this, so clean the air-cleaner element. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages under the engine blower housing are free of obstructions. Inspect the spark plug(s) for pitting, fouling, or incorrect gap, and replace if necessary. Finally, there may be incorrect fuel in the fuel tank, so drain the tank and replace the fuel with the proper type.
  • M
    Melissa RandallAug 23, 2025
    Why won't my Toro 74675 engine start?
    • M
      Michelle ContrerasAug 23, 2025
      If your Toro Lawn Mower engine isn't starting, starts with difficulty, or won't stay running, several factors could be at play. Make sure the fuel tank isn't empty by filling it. Ensure the choke is on. A dirty air cleaner can cause issues, so clean or replace it. Check that the spark plug wire(s) is securely connected to the spark plug. Consider replacing the spark plug(s) with a new, correctly gapped one. Replace the fuel filter if it's clogged. Ensure the fuel tank is filled with the proper type of fuel and that the oil level in the crankcase is adequate by adding oil if needed.
  • A
    Amy RobertsAug 26, 2025
    Why Toro Lawn Mower engine does not start?
    • B
      Brent MccarthyAug 26, 2025
      Your Toro Lawn Mower engine might not be starting due to several reasons. Check if the fuel tank is empty and fill it if needed. Ensure the choke is on. A dirty air cleaner can also be the culprit, so clean or replace it. Inspect the spark plug wire(s) and ensure they are properly connected. The spark plug(s) might be pitted, fouled, or have an incorrect gap, in which case you should install a new one with the correct gap. Also, check for dirt in the fuel filter and replace it if necessary. Low oil level in the crankcase may also cause this issue, so add oil if needed. Finally, ensure that the fuel tank has the proper type of fuel.
  • N
    nicholsjamesAug 26, 2025
    What to do if my Toro 74675 engine won't start?
    • D
      Dr. Robert Grant PhDAug 27, 2025
      If your Toro Lawn Mower engine does not start, starts hard, or fails to keep running, start by checking if the fuel tank is empty and fill it if necessary. Ensure the choke is on by moving the choke lever to the On position. Inspect the air cleaner for dirt and clean or replace the element. Verify that the spark plug wire(s) is securely installed on the spark plug. Check the spark plug(s) for pitting, fouling, or incorrect gap and replace if needed. If there is dirt in the fuel filter, replace it. If there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type. Finally, check the oil level in the crankcase and add oil if it is low. If you suspect dirt, water, or stale fuel is in fuel system, contact an Authorized Service Dealer.

Toro 74675 Specifications

General IconGeneral
Drive TypeRear-Wheel Drive
Deck MaterialSteel
Starter TypeRecoil
Mulching CapabilityYes
Bagging CapabilityYes
Side DischargeYes
Fuel Capacity3 gallons
Fuel Tank Capacity3 gallons
Cutting Width22" (56 cm)

Related product manuals