Toro 74676 User Manual

60 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FormNo.3417-397RevA

TimeCutter

®

SW4200orSW5000

RidingMower

ModelNo.74676—SerialNo.400000000andUp

ModelNo.74680—SerialNo.400220000andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3417-397*A

Table of Contents

Questions and Answers:

M
Michelle BakerSep 12, 2025
Why is my Toro 74676 vibrating abnormally?
- C
  Charles RodriguezSep 12, 2025
  If you're experiencing abnormal vibration with your Toro Lawn Mower, here are some things to inspect: 1. Check if the engine mounting bolts are loose and tighten them. 2. Ensure the engine pulley, idler pulley, or blade pulley is not loose and tighten the appropriate pulley. 3. If the cutting blade(s) is/are bent or unbalanced, install a new cutting blade(s). 4. Also, make sure the blade mounting bolt is tightened.
S
stephenwardAug 25, 2025
Why Toro 74676 engine will not start?
- N
  Nicholas RodriguezAug 25, 2025
  Your Toro Lawn Mower engine might fail to start due to several reasons. The fuel tank may be empty, so fill it. The air cleaner could be dirty; in this case, clean or replace the air cleaner element. A loose or disconnected spark plug wire could also be the culprit; install the wire on the spark plug. Alternatively, the spark plug may be pitted, fouled, or have an incorrect gap; install a new, correctly gapped spark plug. Other potential causes include dirt in the fuel filter (replace the fuel filter), incorrect fuel in the fuel tank (drain the tank and replace the fuel with the proper type), or a low oil level in the crankcase (add oil). If the problem persists, it may be due to dirt, water, or stale fuel in the fuel system.
B
brian59Aug 25, 2025
Why Toro Lawn Mower engine does not start?
- H
  Hannah TorresAug 26, 2025
  Your Toro Lawn Mower engine might not be starting due to several reasons. Check if the fuel tank is empty and fill it if needed. Ensure the choke is on. A dirty air cleaner can also be the culprit, so clean or replace it. Inspect the spark plug wire(s) and ensure they are properly connected. The spark plug(s) might be pitted, fouled, or have an incorrect gap, in which case you should install a new one with the correct gap. Also, check for dirt in the fuel filter and replace it if necessary. Low oil level in the crankcase may also cause this issue, so add oil if needed. Finally, ensure that the fuel tank has the proper type of fuel.
S
Shelley WestAug 26, 2025
What to do if my Toro Lawn Mower engine won't start?
- C
  Connie StevensAug 27, 2025
  If your Toro Lawn Mower engine does not start, starts hard, or fails to keep running, start by checking if the fuel tank is empty and fill it if necessary. Ensure the choke is on by moving the choke lever to the On position. Inspect the air cleaner for dirt and clean or replace the element. Verify that the spark plug wire(s) is securely installed on the spark plug. Check the spark plug(s) for pitting, fouling, or incorrect gap and replace if needed. If there is dirt in the fuel filter, replace it. If there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type. Finally, check the oil level in the crankcase and add oil if it is low. If you suspect dirt, water, or stale fuel is in fuel system, contact an Authorized Service Dealer.
N
Nicholas TranAug 27, 2025
How to fix Toro 74676 Lawn Mower when the starter does not crank?
- R
  rogersmitchellAug 27, 2025
  If the starter on your Toro Lawn Mower does not crank, make sure the blade-control switch is disengaged. If not, move the blade-control switch to Disengaged. Check the battery and charge it if it's dead. Inspect the electrical connections for corrosion or looseness and ensure they have good contact. Also, check the fuse and replace it if it's blown. If a relay or switch is damaged, contact an Authorized Service Dealer.
C
Cynthia ThomasSep 12, 2025
What to do if my Toro 74676 Lawn Mower starter does not crank?
- S
  sblairSep 12, 2025
  If the starter on your Toro Lawn Mower isn't cranking, here are a few things to check: 1. Ensure the blade-control switch is disengaged. 2. The battery might be dead, so charge it. 3. Check the electrical connections for corrosion or looseness and ensure they have good contact. 4. A blown fuse could also be the culprit, so replace it.
F
Frank Montgomery DVMSep 8, 2025
What to do if the blades do not rotate on my Toro 74676?
- A
  angelabrownSep 8, 2025
  If the blades on your Toro Lawn Mower do not rotate, install a new drive belt if the current one is worn, loose, or broken. If the drive belt is off of the pulley, install it, ensuring the adjusting shafts and belt guides are in the correct position. If the power takeoff (PTO) switch or PTO clutch is faulty, contact an Authorized Service Dealer. Install a new mower belt if the current one is worn, loose, or broken.
A
Alicia PayneSep 9, 2025
How to fix Toro Lawn Mower when the engine overheats?
- J
  Jennifer WalkerSep 10, 2025
  If your Toro Lawn Mower engine is overheating, several factors could be the cause. First, the engine load may be excessive, so reduce your ground speed. Second, the oil level in the crankcase may be low, so add oil. Third, the cooling fins and air passages under the engine blower housing may be obstructed, so remove any obstructions. Lastly, the air cleaner might be dirty, so clean or replace it.
K
Kelsey PatelSep 3, 2025
Why is my Toro 74676 Lawn Mower cutting height uneven?
- A
  Adrian RossSep 3, 2025
  Uneven cutting height with your Toro Lawn Mower can be due to several reasons. The blade(s) might not be sharp, so sharpen them. A cutting blade(s) may be bent, so install a new cutting blade(s). Ensure the mower is level from side-to-side and front-to-rear. Check that the anti-scalp wheel is set correctly and adjust its height if needed. A dirty mower underside can also cause this, so clean it. Finally, verify that the tire pressure is correct and adjust it accordingly. If a blade spindle is bent, it is recommended to contact an Authorized Service Dealer.
B
Brad ChenAug 31, 2025
Why are the blades not rotating on my Toro Lawn Mower?
- J
  juliesmithAug 31, 2025
  If the blades on your Toro Lawn Mower aren't rotating, check the following: 1. The drive belt may be worn, loose, or broken, so install a new one. 2. If the drive belt is off the pulley, install it and check the adjusting shafts and belt guides for the correct position. 3. The mower belt may be worn, loose, or broken, so install a new mower belt.

Toro 74676 Specifications

General

Model	74676
Type	Walk Behind Mower
Engine Displacement	163 cc
Drive Type	Self-Propelled
Deck Material	Steel
Speed Control	Variable Speed
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Engine	Briggs & Stratton
Cutting Width	22 inches
Start Type	Recoil
Fuel Capacity	1.2 quarts
Cutting Height	1 inch to 4 inches
Wheel Size	7 inches front
Fuel Tank Capacity	1.2 quarts

Related product manuals

Preview: Toro 74675

Preview: Toro 74603

Preview: Toro 74621

Preview: Toro 74627

Preview: Toro 74665