CHASSIS
3-88 Toro GrandStand Service Manual
3
72. Repeat steps 69 through 71 on the other pump.
73. Remove the two sets of carriage bolts, washers and
nuts securing the pump to the engine base (Fig.
0330).
Fig. 0330 DSCN-1078a
74. Repeat step 73 on the other pump.
75. Remove both pumps from the engine base (Fig.
0331).
Fig. 0331 DSCN-1083a
76. Remove the bolt and nut securing the idler assembly
to the engine base, then remove the assembly (Fig.
0332).
Fig. 0332 DSCN-1086a
77. 2010 only: Remove the cable tie securing the
clutch wires to the clutch stop (Fig. 0333).
Fig. 0333 DSCN-1087a
To Next Page
Loading...
