CHASSIS
3-106 Toro GrandStand Service Manual
3
51. Position the right hand lift plate over the grease
block with the bolt hole pattern aligned with the
mating pattern on the engine base (Fig. 0398).
Fig. 0398 DSCN-1233a
52. 2009 only: Loosely install four carriage bolts,
Belleville washers and nuts (Fig. 0399).
Fig. 0399 DSCN-1240a
53. 2009 only: Tighten the four sets of fasteners.
54. 2010 only: The right side lift plate is secured with
three long carriage bolts and one short (Fig. 0400).
Fig. 0400 DSCN-0768a
55. 2010 only: Loosely install the short carriage bolt
and nut in the upper left bolt hole (Fig. 0401).
Fig. 0401 DSCN-1236a
To Next Page
Loading...
